Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving all of New Mexico

CHI Overhead Doors Garage Door Cable Repair in New Mexico

Frayed, snapped or slipped lift cables replaced and the door re-leveled. Typical cost $150-$350.

Our CHI Overhead Doors garage door cable repair service in New Mexico comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Frayed, snapped or slipped lift cables replaced and the door re-leveled. Whether your CHI Overhead Doors garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

Is it time for CHI Overhead Doors garage door cable repair?

  • A cable hanging loose or off its drum
  • The door is crooked, with one side higher than the other
  • Frayed or rusty strands near the bottom bracket
  • The door stopped suddenly and won't move

Common causes

  • Rust and wear at the bottom bracket, where cables sit near wet ground
  • A broken spring that let the cable go slack and unwind
  • Drums that have slipped on the shaft
  • The door hitting an obstruction while closing

What you can check yourself

  • Don't operate the door if a cable is loose. It can come off its tracks.
  • Look at both bottom corners for frayed or rusted cable.
  • Never loosen the bottom brackets, because they are under full spring tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Secure the door and remove spring tension
  2. Replace both lift cables so they wear evenly
  3. Re-seat the cables on the drums and set them to equal tension
  4. Inspect the bottom brackets, drums and springs
  5. Level and balance the door and test it

How much does CHI Overhead Doors garage door cable repair cost?

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

CHI Overhead Doors Garage Door Cable Repair in New Mexico

Fine dust in New Mexico packs into roller bearings and the track, so rollers start to drag and squeal well before they are worn out.

We cover 82 cities and towns across New Mexico. Find CHI Overhead Doors garage door cable repair in your city:

CHI Overhead Doors Garage Door Cable Repair: frequently asked questions

How much does CHI Overhead Doors garage door cable repair cost in New Mexico?

CHI Overhead Doors Garage Door Cable Repair typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors garage door cable repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors garage door cable repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where New Mexico or your city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in New Mexico

Linear Opener Circuit Board Replacement

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $175-$400

Richards-Wilcox Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Garage Door Replacement

Old or damaged doors replaced with a new door, springs, tracks and hardware.

Typical $1,200-$5,000

Amarr Garage Door Repair

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$450

Windsor Door Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Martin Door Off-Track Garage Door Repair

Doors that have come off their tracks secured, re-hung and realigned.

Typical $175-$450

Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Linear Remote & Keypad Programming

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $50-$150

Cornell Cookson Commercial Garage Door Repair

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $250-$1,000

Genie Remote & Keypad Programming

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $50-$150

Wayne Dalton Garage Door Panel Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $300-$900

Ideal Door Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Garage door stuck, noisy or broken?

Talk to a garage door technician in New Mexico now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote